From one of the worlds largest casino hopper manufacturers, Suzo, comes the Escendo Escalator Hopper. This hopper solves most existing escalator hopper problems. These improvements are the result of nearly 5 years of development and have resulted in two world wide patents.

• The Escendo Escalator Hopper has a unique rotor system and brush track.
• The patented rotor system ensures one-by-one coin entry into the brush track, eliminating shingling (overlapping coins) which mostly results in a coin jam.
• As the coin comes into the track the coin is pushed towards the back plate by the patented brushes. It is totally insensitive to damaged or bent coins which often end up in a hopper jam.
• The brushes in the track are placed in a diagonal upward position pushing the coin upwards but preveenting the coin from going down again. The result is low power consumption
  and less wearing parts.
• The planetary gearbox system guarantees low power consumption and
  silent operation. (Optionally available on 12VDC)
• Low maintenance and easy accessible are key in the Escendo hopper. The coin track is open on one side for visual inspection.
• The combination of these features has resulted in a service friendly hopper with extremely high performance.

Features:

• High performance and reliability.
• Low maintenance and easy accessible.
• Planetary gearbox for low power consumption and silent operation.
• Easy to change denomination between 0.83” – 1.18” (21 - 30 mm) or 1.19” – 1.57” (30.1 - 40 mm)
• Choice of optical or induction sensors for coin read out.
• Customized cups and frames possible, equal to side pay-out hoppers from Suzo.
• Selection of control boards available.

Technical specifications:

• Applicable coin size: diameter 0.83” – 1.57” (21 - 40 mm), thickness 0.06” – 0.13” (1.5 - 3.2 mm)
  On special request: coin size diameter 1.77” (45mm)
• Pay out speed: 210 - 420 coins per minute depending coin size.
• Voltage 12 or 24VDC.
• Power consumption (current):
  12VDC nominal: 1Amp / peak 3.0Amp 24VDC nominal: 0.6Amp / peak: 2.5Amp
• Available in 3 heights: Pay-out height Overall height
  19.09” (485mm) 21.14” (537mm)
  21.06” (535mm) 23.11” (587mm)
  23.03” (585mm) 25.08” (637mm)
• Counting method: Optical sensors with pulse mode and opto check.
• Pay out side: standard right, optional left hand side.
• Operating temperature: 32º - 140ºF (0º - 60ºC)