• Updated Type II 45 Cal. Optical guns
• Base of Handle now has three screws vs. only one in the original design
• The diameter of the internal bosses and chamfers has been increased for increased strength and durability
• The Wall thickness within the "recoil" solenoid area has been increased for improved strength
• The new improved version is identified by Revision "E" or higher. You can find this molded on the inside of the plastic gun halves
• Will not work with older Type I rubber hoses
• Kit contains the following items
  -Left plastic gun half
  (Revised Type II) 96-0286-XX
  -Right plastic gun half
  (Revised Type II) 96-0285-XX
  -Gun handle screws
  (5) 43-0095-00
  -Gun handle screws
  (2) 43-0336-00
  -Gun handle nuts
  (2) 43-0094-00
  

Optical Gun Halves and PCB Update Kit - Red

Optical Gun Halves and PCB Update Kit - Blue

Optical Gun Halves and PCB Update Kit - Green

Optical Gun Halves and PCB Update Kit - Orange

Optical Gun Halves and PCB Update Kit - Deep Purple

Optical Gun Halves and PCB Update Kit - Light Blue

Optical Gun Halves and PCB Update Kit - Pink